SSRScientific and Social Research2661-43322981-9946Bio-Byword Scientific Publishing Pty. Ltd.10.26689/ssr.v6i11.8817ArticleOperational Strategy of Nonuniform Air Supply in Cleanroomshttps://artdesignp.com/journal/SSR/6/11/10.26689/ssr.v6i11.8817WangXin,ZhangMinwei,LiHao,WangLi,LiJun,ZouZhijun20246112024-11-29To ensure that cleanroom cleanliness requirements are met, the current design and operation of cleanrooms generally necessitate the fan filter unit (FFU) to open. However, deploying an excessive number of FFUs may lead to an air volume redundancy problem, which can reduce air volume. Conversely, reducing FFUs and their airflow might also increase the risk of uneven indoor airflow distribution and particle concentration. This study analyzes the influence of the nonuniform operational strategy of FFUs (including the opening rate, arrangement position, and air velocity of FFUs) on the distribution of airborne particulate matter concentration in the cleanroom using CFD simulation technology. Results showed that opening only the top part of the source FFU can significantly reduce the indoor particulate concentration in the cleanroom and maintain the cleanliness that meets the requirements of cleanrooms. In the case of the same number of air exchanges, increasing the air velocity of the upper FFU of the indoor airborne particulate pollution source has a significant effect on the purification of indoor particulate matter in the cleanroom. These results show that the nonuniform air supply from the upper FFU of the source has good purification performance for airborne particles in a typical cleanroom.

Sun W, 2017, ASHRAE Design Guide for Cleanrooms: Fundamentals, Systems, and Performance. ASHRAE, Atlanta, 448.

Chalk S, 2013, New Challenges to the Cleanroom Paradigm for Multi-product Facilities. BioPharm International, 26(5): 38–47.

May GS, Spanos CJ, 2006, Fundamentals of Semiconductor Manufacturing and Process Control. John Wiley & Sons, New Jersey.

Khoo CY, Lee CC, Hu SC, 2012, An Experimental Study on the Influences of Air Change Rate and Free Area Ratio of Raised-floor on Cleanroom Particle Concentrations. Building and Environment, 2012(48): 84–88.

Xu T, 2004, Considerations for Efficient Airflow Design in Cleanrooms. Journal of the IEST, 47(1): 24–28.

International Organization for Standardization, 2015, Cleanrooms and Associated Controlled Environments—Part 1: Classification of Air Cleanliness. ISO 14633-1: 2015, 1999.

Chen J, 2021, Airflow Motion Distribution and Cleanliness Recovery Characteristics in the Pharmaceutical Cleanroom, thesis, Hunan University of Technology.

Shao J, 2013, Investigation on Effects of Structure Parameters of Plenum Chamber on Outlet Flow Field Uniformity, thesis, Dalian University of Technology.

Yang Y, 2022, Study on the Effect of Various Return Air Modes on the Particle Concentration Distribution by the Orifice Plate Air Supply in the Clean Room, thesis, Tianjin University of Commerce.

Tao S, Li S, Kou B, et al., 2022, Analysis on the Influence of FFU and Raised Floor Layout on Air Flow in Semiconductor Clean Room. Contamination Control & Air-Conditioning Technology, 2022(5): 108–112.

Shao X, Liang S, Zhao J, et al., 2021, Experimental Investigation of Particle Dispersion in Cleanrooms of Electronic Industry under Different Area Ratios and Speeds of Fan Filter Units. Journal of Building Engineering, 2021(43): 102590.

Shao X, Hao Y, Liang S, et al., 2022, Experimental Characterization of Particle Distribution during the Process of Reducing the Air Supply Volume in an Electronic Industry Cleanroom. Journal of Building Engineering, 2022(45): 103594.

Whyte W, Whyte WM, Ward S, 2018, Ventilation Effectiveness in Cleanrooms and its Relation to Decay Rate, Recovery Rate, and Air Change Rate. European Journal of Parenteral and Pharmaceutical Sciences, 23(4): 126–134.

Loomans MGLC, Molenaar PCA, Kort HSM, et al., 2019, Energy Demand Reduction in Pharmaceutical Cleanrooms through Optimization of Ventilation. Energy and Buildings, 2019(202): 109346.

Yang L, Huang C, 2014, Study on Characteristics and Two Zone Model of Multi Air Distribution for Cleanroom. Contamination Control & Air-Conditioning Technology, 2014(1): 5–9.

Yin J, Liu X, Guan B, et al., 2021, Performance Analysis and Energy Saving Potential of Air Conditioning Systems in Semiconductor Cleanrooms. Journal of Building Engineering, 2021(37): 102158.

Zhuang C, Shan K, Wang S, 2021, Coordinated Demand-controlled Ventilation Strategy for Energy-efficient Operation in Multi-zone Cleanroom Air-conditioning Systems. Building and Environment, 2021(191): 107588.

Liang S, Liu Y, Shao X, et al., 2022, Particle Distribution Characteristics of Electronic Industry Clean Room with Different FFU Air Volume. Building Energy Efficiency, 50(1): 96–101.

China National Standards, 2013, GB 50073: Code for Design of Clean Room.

Zhao J, Shao X, Li X, et al., 2021, Theoretical Expression for Clean Air Volume in Cleanrooms with Non-uniform Environments. Building and Environment, 2021(204): 108168.

Elsaey AAE, Fouad MA, 2023, Numerical Investigation of using FDCU on Temperature Distribution in Non-Unidirectional Cleanrooms. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 105(1): 15–30.

Zhang F, Fan Y, Liu J, et al., 2022, Study on Human Particle Emission Rates of Cleanrooms. Journal of HV & AC, 52(10): 168–173.

Zhou L, Sun W, Huang C, et al., 2017, Studies on Comparison of Particle Concentration Models for Cleanroom. Procedia Engineering, 2017(205): 3308–3315.

Fluent Inc., 2006, F.L.U.E N.T. User’s Guide. Fluent Inc., Lebanon.

Yang C, Yang X, Xu T, et al., 2009, Optimization of Bathroom Ventilation Design for an ISO Class 5 Clean Ward, in Building Simulation. Springer Berlin, Heidelberg, 133–142.

Liu Z, Zhu H, Song Y, et al., 2022, Quantitative Distribution of Human Exhaled Particles in a Ventilation Room, in Building Simulation. Tsinghua University Press, Beijing, 1–12.